Huawei ECC800 User Manual page 33

ECC800 Data Center Controller
User Manual (for ECC800-Pro)
Indicators
Table 3-14 Indicators on the ECC800-Pro main control module
Indicat
or
RUN
ALM
RF_Z
SW Button
Table 3-15 SW button description
Function
Description
Wireless network
RF_Z (802.15.4)
pairing
Issue 06 (2020-04-22)
Color Name
Green Running status
indicator
Red Alarm indicator
Green Communication
status indicator
Operation Description
In non-wireless network (802.15.4)
pairing mode, press and hold down the
button for 3s to 5s to enter the wireless
network pairing mode.
In wireless network (802.15.4) pairing
mode, press and hold down the button for
3s to 5s to exit the pairing mode; or the
system automatically exits the pairing
mode after 30 minutes without pressing
Copyright © Huawei Technologies Co., Ltd.
Status Description
Steady on The power supply is normal, the
program is being loaded.
Off The power supply is abnormal.
Blinking at The software runs properly (the
long indicator blinks at 0.5 Hz, on for
intervals 1s and then off for 1s) or the
ECC800-Pro registers with the
NetEco successfully.
Blinking at The ECC800-Pro does not
short register with the NetEco (the
intervals indicator blinks at 5 Hz, on for
0.125s and then off for 0.125s).
Steady on A system failure alarm is
generated.
Off The system is normal.
Blinking at A network is set up, and no
long node access is allowed (the
intervals indicator blinks at 0.5 Hz, on for
1s and then off for 1s).
Blinking at A network is set up, and node
super short access is allowed (the indicator
intervals blinks at 10 Hz, on for 0.05s and
then off for 0.05s).
3 Device Description
Indicator Status
The RF_Z indicator is
blinking at super short
intervals.
The RF_Z indicator is
blinking at long
intervals.
22