How To Set And Add A Netcol5000-C030 (Over Modbus Rtu) - Huawei ECC800 User Manual

Data center controller
Hide thumbs Also See for ECC800:
Table of Contents

Advertisement

ECC800 Data Center Controller
User Manual (for ECC800-Pro)

8.1.6.16 How to Set and Add a NetCol5000-C030 (over Modbus RTU)?

Prerequisites
One end of the straight-through cable has been connected to the J73 communications port on
the NetCol5000-C030 main control board, and the other end has been connected to the COM
port on the ECC800-Pro collector or ETH converter.
Procedure
Step 1 Set NetCol5000-C030 monitoring parameters.
1.
2.
Step 2 Add a NetCol5000-C030.
1.
2.
Table 8-14 Adding a NetCol5000-C030
Path
Choose System
Settings >
Device
Management
and click Add
Device. The
parameters for
adding devices
are displayed.
3.
Issue 06 (2020-04-22)
Enter the NetCol5000-C030 home page, click Settings, choose the user name Admin
and enter password 000001. After login, the settings screen of the NetCol5000-C030 is
displayed.
Choose Settings > Comm Settings > Modbus Settings, choose Baud rate to 9600 and
set Comm address to 1.
The earlier version has Protocol setting on the screen. The actual screen prevails.
Log in to the ECC800-Pro WebUI as an administrator.
Add a NetCol5000-C030.
Parameter
Name
Device attribute
Device Type
Connect To
Communications
Port
Device Address
Click Test Connect to check whether the NetCol5000-C030 connects to the
ECC800-Pro properly.
If the NetCol5000-C030 connects to the ECC800-Pro properly, click Confirm. The
connected devices are displayed in the Number of connected devices list.
Copyright © Huawei Technologies Co., Ltd.
Setting
Select Air Conditioner from the drop-down list
box.
Select NetCol5000-C from the drop-down list box.
Select ECC800 from the drop-down list box.
Select COM1 from the drop-down list box.
NOTE
The setting example indicates that the NetCol5000-C030
is connected to the COM1 port on the ECC800-Pro. If the
NetCol5000-C030 is connected to another port, enter the
number of the connected port.
In this example, Device Address is set to 1. During
actual configuration, set the device address for the
NetCol5000-C030 based on the actual situation.
8 FAQ
246

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ecc800-pro

Table of Contents