Setting And Adding A Netcol5000-C030 (Over Modbus Rtu) - Huawei ECC800 User Manual

ECC800 Data Center Controller
User Manual
----End

5.3.6 Setting and Adding a NetCol5000-C030 (over Modbus RTU)

Prerequisites
In this example, a straight-through cable is used to connect the NetCol5000-C030 to the COM
port on the ECC800.
Procedure
Step 1 Set NetCol5000-C030 monitoring parameters.
1.
2.
Step 2 Add a NetCol5000-C030.
1.
2.
Table 5-6 Adding a NetCol5000-C030
Path
System
Settings >
Device
Management
3.
Issue 02 (2019-02-28)
Enter the NetCol5000-C030 home page, click Settings, choose user name Admin and
enter password 000001. After login, the settings screen of the NetCol5000-C030 is
displayed.
Choose Settings > Comm Settings > Modbus Settings, choose Baud rate to 9600 and
set Comm address to 1.
The earlier version has Protocol setting on the screen. The actual screen prevails.
Log in to the ECC800 WebUI as an administrator.
Add a NetCol5000-C030.
Parameter
Name
Device type
Connect to
Communications
port
Device address
Click Connect Test to check whether the NetCol5000-C030 connects to the ECC800
properly.
− If the NetCol5000-C030 connects to the ECC800 properly, click Add Device.
− If the NetCol5000-C030 does not connect to the ECC800 properly, check whether
the cable between the NetCol5000-C030 and the ECC800 is connected properly,
Copyright © Huawei Technologies Co., Ltd.
Setting
Select NetCol5000-C030 from the drop-down list
box.
Select ECC800 from the drop-down list box.
Select COM1 from the drop-down list box.
NOTE
The setting example indicates that the NetCol5000-C030
is connected to the COM1 port on the ECC800. If the
NetCol5000-C030 is connected to another port, enter the
number of the connected port.
In this example, Device address is set to 1. During
actual configuration, set the device address for the
NetCol5000-C030 based on the actual situation.
5 Power-On Commissioning
99