How Can I Change The Ecc800 Ip Address On The Webui; How To Set Parameters For Alarm Enable, Severity, And Loudspeaker - Huawei ECC800 User Manual

ECC800 Data Center Controller
User Manual
Step 8 Select the key file to be imported from the PC and click Upload.
Step 9 Specify Key cryptography and Confirm key cryptography.
Step 10 Click Submit.
----End

9.1.6 How Can I Change the ECC800 IP Address on the WebUI?

Context
You have obtained the IP address, subnet mask, and default gateway information planned for
the ECC800.
Procedure
Step 1 Log in to the ECC800 WebUI as an administrator.
Step 2 Choose System Settings > Monitor Module IP and change the IP, subnet mask, and default
gateway information for the ECC800 as planned.
Step 3 Click Submit.
Step 4 In the displayed The WebUI will exit or not respond after the new IP address is set. You
need to log in again with the new IP address. Do you want to change the IP address?
dialog box, click OK.
----End
9.1.7 How to Set Parameters for Alarm Enable, Severity, and
Loudspeaker?
Context


Procedure
Step 1 Log in to the ECC800 WebUI as an administrator.
Step 2 Choose System Settings > Alarm Parameters.
Step 3 Select ECC800 from the drop-down list box and click Confirm.
Step 4 Set Operation log full to Enable or Disable under Enable Alarm as required. Set Severity
to Critical, Major, Minor, or Warning as required. Set Loudspeaker to Enable or Disable
as required.
Step 5 Click Submit.
Issue 02 (2019-02-28)
You can set parameters under Enable Alarm, Severity, and Loudspeaker based on
requirements. When an alarm is set to Disable, the ECC800 will not report this alarm. If
an alarm is associated with the loudspeaker and Loudspeaker is set to Enable, the
loudspeaker produces sound when the alarm is generated.
The setting methods for different alarms are the same. This section describes how to set
the Operation log full alarm for ECC800.
Copyright © Huawei Technologies Co., Ltd.
9 FAQ
201