Huawei ECC800 User Manual page 157

ECC800 Data Center Controller
User Manual
1.
2.
3.
4.
5.
6.
7.
Step 2 Set camera parameters and commission the camera according to the document delivered with
the camera.
1.
2.
3.
4.
Set coding protocol to H.264.
Issue 02 (2019-02-28)
 If the communications cable between the smart ETH gateway and the ECC800 is disconnected
before the camera is powered on for the first time, the camera IP address is not automatically
allocated by the ECC800. Therefore, you do not have to perform
 If the VCN500 is configured, obtain a dynamic IP address (192.168.248.XX, for example) for the
camera by selecting Adding Cameras Using a Wizard on the C/S (Client/Server) client, and then
log in to the camera WebUI using the dynamic address and perform
Disconnect the communications cable between the smart ETH gateway and the ECC800.
Press the Reset button on the camera to restore the camera IP address to the factory
default.
Use a network cable to connect the PC to an idle network port on the smart ETH
gateway. Set the PC IP address and camera IP address (192.168.0.120 by default) in the
same network segment.
Enter the camera IP address (192.168.0.120 by default) in the address bar of the Internet
Explorer and press Enter button.
Enter the preset user name admin and the preset password HuaWei123, and click Log
In.
Choose Settings > Network Configuration > Network Parameters and set the camera
IP address to 192.168.248.50.
Set IP address to 192.168.248.50, Subnet mask to 255.255.255.0, and Gateway IP address to
192.168.248.1. The values here are examples. The actual values prevail.
Reconnect the communications cable between the smart ETH gateway and the ECC800.
Set the PC IP address and camera IP address (192.168.248.50) in the same network
segment, and log in to the camera WebUI again.
Preview the site situation in real time and check the camera coverage through videos.
Adjust the lens if necessary.
(Optional) If you use the SD card when no VCM500 is configured, perform
commissioning by following the instructions in 5.9.5 Commissioning IPC6325 Camera
(SD Card Configured).
Set camera stream type, primary stream, and secondary stream 1 parameters.
Copyright © Huawei Technologies Co., Ltd.
5 Power-On Commissioning
Step 1.1 and Step 1.2.
Step 1.6.
148