Setting Parameters For The Smart Busway - Huawei ECC800 User Manual

ECC800 Data Center Controller
User Manual
Path
System
Settings >
Device
Management
3.
----End

5.3.12 Setting Parameters for the Smart Busway

Context
If the smart busway is used, general input units and power distribution units communicate
with the ECC800 using the MAC-Modbus protocol. After the general input units and power
distribution units properly connect to the ECC800, the ECC800 automatically identifies the
units.
Then, you need to set parameters for the general input units and power distribution units;
otherwise, a false alarm may be generated.
Procedure
Step 1 Set parameters for general input units on the ECC800 WebUI.
1.
Table 5-9 Power distribution settings for a general input unit
Path
Issue 02 (2019-02-28)
Parameter
Name
Device type
Connect to
Communications
port
Device address
Click Connect Test to check whether the PDU2000-M(C) connects to the ECC800
properly.
− If the PDU2000-M(C) connects to the ECC800 properly, click Add Device.
− If the PDU2000-M(C) does not connect to the ECC800 properly, check whether the
cable between the PDU2000-M(C) and the ECC800 is connected properly, whether
the PDU2000-M(C) and ECC800 are running properly, and whether the input
parameters are consistent with the PDU2000-M(C) parameters.
Set parameters for general input unit 1.
Copyright © Huawei Technologies Co., Ltd.
Setting
Select PDU2000-M(C) from the drop-down list
box.
Select ECC800 from the drop-down list box.
Select COM1 from the drop-down list box.
NOTE
The setting example indicates that the PDU2000-M(C) is
connected to the COM1 port on the ECC800. If the
PDU2000-M(C) is connected to another port, enter the
number of the connected port.
In this example, Device address is set to 1. During
actual configuration, set the device address for the
PDU2000-M(C) based on the actual situation.
Parameter Default
Name Value
5 Power-On Commissioning
Setting
105