Power-On Commissioning; Setting The Date And Time - Huawei ECC800 User Manual

ECC800 Data Center Controller
User Manual
Prerequisites




Context
After installing or replacing the device or ECC800, set monitoring parameters and add the
device.

5.1 Setting the Date and Time

Procedure
Step 1 Choose System Settings > Time Settings.
Step 2 Set the time zone, date, and time, and click Submit.
Step 3 (Optional) If the NTP server is used for time synchronization, select NTP Server Sync, set
NTP Primary Server IP, NTP Backup Server IP, Port Number, and Sync Interval (Min),
and click Submit.
----End
Issue 02 (2019-02-28)
5
The hardware and cable installation check is complete for controller components
according to data center specifications and requirements.
The device and ECC800 have been powered on.
You have obtained the ECC800 IP address as well as the user name and password used
for WebUI login.
A PC with an IP address in the same network segment as the ECC800 IP address is
prepared, and the PC has connected to the WAN_1 port on the ECC800.
Copyright © Huawei Technologies Co., Ltd.

Power-On Commissioning

5 Power-On Commissioning
91