Setting And Adding A Pdu8000 Or Integrated Pdu (Over Modbus-Tcp); Setting And Adding A Pdu8000 (Over Modbus-Rtu) - Huawei ECC800 User Manual

ECC800 Data Center Controller
User Manual
5.3.9 Setting and Adding a PDU8000 or integrated PDU (over
Modbus-TCP)
Prerequisites
In this example, a straight-through cable is used to connect the PDU8000 or integrated PDU
to the PoE port on the smart ETH gateway.
Context
The method of connecting the PDU8000 to the ECC800 is the same as that for the integrated
PDU. Connecting the integrated PDU to the ECC800 by following the instructions in this
section.
Procedure
Step 1 Set the PDU8000 monitoring parameters.
1.
2.
3.
----End

5.3.10 Setting and Adding a PDU8000 (over Modbus-RTU)

Prerequisites
In this example, a straight-through cable is used to connect the PDU8000 to the COM port on
the ECC800.
Procedure
Step 1 Set the PDU8000 monitoring parameters.
1.
2.
3.
Issue 02 (2019-02-28)
Enter thePDU8000 home page, tap System Info.
Choose System Info > Settings, enter the user name admin and password 000001, and
press .
Tap Communication to set IP address assign to Automatic(DHCP) on the displayed
communication settings screen and the PDU8000 is discovered by ECC800
automatically and is connected to the ECC800.
Enter thePDU8000 home page, tap System Info.
Choose System Info > Settings, enter the user name admin and password 000001, and
press .
Tap Communication and check IP address assign to Manual. And set Serial port
baud rate to 9600, and Serial port address to 1 on the displayed communication
settings screen.
Copyright © Huawei Technologies Co., Ltd.
5 Power-On Commissioning
102