How To Set And Add A Pdu8000 Or Integrated Pdf (Over Modbus-Tcp) - Huawei ECC800 User Manual

ECC800 Data Center Controller
User Manual
Table 8-4 Adding a UPS5000-E
Path
Choose System
Settings >
Device
Management
and click Add
Device. The
parameters for
adding devices
are displayed.
3.
4.
----End
8.1.8.4 How to Set and Add a PDU8000 or integrated PDF (over
Modbus-TCP)?
Prerequisites
One end of the straight-through cable has been connected to the FE port on the PDU8000 or
integrated PDF, and the other end has been connected to the POE port on the smart ETH
gateway.
Context
The method of connecting the PDU8000 to the ECC800 is the same as that for the integrated
PDF. Connecting the integrated PDF to the ECC800 by following the instructions in this
section.
Procedure
Step 1 Set the PDU8000 monitoring parameters.
1.
Issue 05 (2019-09-16)
Parameter
Name
Device attribute
Device Type
Connect To
Communications
Port
Device Address
Click Test Connect to check whether the UPS5000-E connects to the ECC800 properly.
− If the UPS5000-E connects to the ECC800 properly, click Confirm. The connected
devices are displayed in the Number of connected devices list.
− If the UPS5000-E does not connect to the ECC800 properly, check whether the
cable between the UPS5000-E and the ECC800 is connected properly, whether the
UPS5000-E and ECC800 are running properly, and whether the input parameters
are consistent with the UPS5000-E parameters.
Choose Monitoring > System > ETH Converter Group > ETH Converter n >
Running Parameters and set Device name to ETH Converter n_Device name.
Enter the PDU8000 home page, tap System Info.
Copyright © Huawei Technologies Co., Ltd.
Setting
Select UPS from the drop-down list box.
Select UPS5000 from the drop-down list box.
Select ETH Converter n from the drop-down list
box.
Select COM1/COM2 from the drop-down list box.
In this example, Device Address is set to 1. During
actual configuration, set the device address for the
UPS5000-E based on the actual situation.
8 FAQ
186