Huawei ECC800 User Manual page 199

ECC800 Data Center Controller
User Manual
Vendor
a: The barcode starts with 21 and is attached to the device.
Procedure
Step 1 Set the PDU2000 monitoring parameters.


Issue 05 (2019-09-16)
Name Displayed on
the WebUI
Set the PDU2000-M (C) monitoring parameters.
The display of a single-phase module is used as an example.
− After the PDU2000-M (C) is powered on, the LCM displays the initialization
screen.
Figure 8-13 PDU2000-M (C) initialization screen
− Press MENU to enter the device communications address screen.
Figure 8-14 PDU2000-M (C) communications settings
− Set address to 1 by pressing DOWN and UP.
− Press MENU to confirm the settings.
The parameter settings take effect only if you press MENU and then the PDU2000-M (C) buzzes and
restarts. If you do not press MENU, the PDU2000-M (C) buzzes and restarts automatically after 30s and
the settings are not saved.
Set the PDU2000-M (H) monitoring parameters
Copyright © Huawei Technologies Co., Ltd.
Eleventh and Twelfth Characters in
Device Barcode
a
8 FAQ
189