Huawei ECC800 User Manual page 39

ECC800 Data Center Controller
User Manual
Item
AI/DI port
DO/DI port
RS485 serial
port expansion
Wiegand
interface
BLINK button
Address DIP
switch
E-label
Indicators
Table 3-20 Access actuator indicator description
Indicator
PWR
RUN
Issue 05 (2019-09-16)
Specifications
Two AI/DI ports, can connect to the fire alarm and exit button
 One 12 V DC power output that controls magnetic locks, terminal

One DI input port for connecting to the door status switch
Two RS485 ports (one route) with the default communications rate of
9600 bit/s, physical port cascading supported (reserved function)
Two Wiegand interfaces, 12 V DC card reader operating power output;
two routes of card readers (non-fingerprint readers) can operate at the
same time.
 Press the button for less than 1 second to start blinking.

Hold down the button for 1–5 seconds to search for a network and
start networking.

Hold down the button for more than 10 seconds to clear network
parameters.
4-pin address DIP switch
Supported
Color
Green
Green
Copyright © Huawei Technologies Co., Ltd.
Name
Power input status
indicator
Communication status
indicator
3 Device Description
Status
 Steady on: The power
input is normal.
 Off: There is no
power input.

Off: The power is
abnormal or the
board program is
loading.
 Blinking at long
intervals: The access
actuator successfully
registers with the
ECC800 and the
software runs
properly (the
indicator blinks at 0.5
Hz, on for 1s and
then off for 1s).

Blinking at short
intervals: The
29