Commissioning A Camera (Smart Eth Gateway Networking Scenario); Commissioning Ipc6325 Cameras - Huawei ECC800 User Manual

ECC800 Data Center Controller
User Manual
Figure 6-5 Camera + VCN connecting to the LAN switch
6.2.3 Commissioning a Camera (Smart ETH Gateway Networking
Scenario)

6.2.3.1 Commissioning IPC6325 Cameras

Prerequisites
If multiple cameras are accessed, retain the connection of one camera and disconnect
connections from other cameras. After commissioning the connected camera, commission
other cameras in the same way.
Ensure that the camera has connected to the smart ETH gateway and the smart ETH gateway
communicates properly with the ECC800.
Context





Table 6-14 IP address plan
Device
Issue 05 (2019-09-16)
The existing network is equipped with the ECC800 that supports the Dynamic Host
Configuration Protocol (DHCP). After the ECC800 and IPC6325 camera are powered on,
the IPC6325 camera automatically obtains an IP address that is in the same network
segment as the ECC800 IP address.
Before commissioning the IPC6325 camera, set the IP address for the IPC6325 camera
based on customer requirements.
Configure the camera/VCN internal IP address and the IP address of the LAN port on the
ECC800 in the same network segment.
Configure the camera/VCN internal IP address and the IP address of the WAN_1 port on
the ECC800 in the same network.
Set the internal and external IP addresses as planned by the customer. The following IP
addresses are just examples.
Internal IP Address
Copyright © Huawei Technologies Co., Ltd.
6 Feature Description
External IP Address
108