Huawei ECC800 User Manual page 149

ECC800 Data Center Controller
User Manual
Procedure
Step 1 Press the networking switch on the iBOX for 2 seconds. The ALM indicator blinks red once,
and the RF_Z indicator turns from steady green to blinking green at super short intervals,
which indicates that the iBOX is being networked.
Step 2 Press the iBAT networking switch for 2 seconds. When the RUN/ALM indicator turns from
steady red to blinking green at super short intervals (iBattery 2.0) or short intervals (iBattery
3.0), and finally to blinking green at long intervals, the iBAT connects to the iBOX network.
Step 3 Perform networking operations on the next iBAT only after networking for the previous iBAT
is successful. Repeat
Step 4 Press the iBOX networking switch for 2 seconds. When the RF_Z indicator on the iBOX
turns from blinking green at super short intervals to blinking green at long intervals, the
networking is complete.
Step 5 (Optional) If multiple iBOXs are cascaded, repeat
remaining iBOXs and iBATs.
----End
Issue 05 (2019-09-16)
− Blinking at short intervals: The indicator is on for 0.125 seconds and then off for
0.125 seconds alternately.
 It is recommended that iBATs be networked from the positive battery string terminal according to
the battery cable connection sequence.
 Batteries are numbered depending on the sequence of connecting iBATs to the iBOXs.
Step 2
After the networking is complete, if the ALM indicator on the iBOX is steady on, the number of devices
online is smaller than the value of iBAT Number. Check that iBAT Number is set to a correct value
and that the iBAT is successfully networked.
Copyright © Huawei Technologies Co., Ltd.
to add other iBATs to the iBOX network.
Step 1
6 Feature Description
to Step 4 to perform networking for
139