How Should I Add The Devices Accessed Through A Smart Eth Gateway Over Modbus-Tcp To The Ecc800 Webui - Huawei ECC800 User Manual

ECC800 Data Center Controller
User Manual
----End
8.1.27 How Should I Add the Devices Accessed Through a Smart
ETH Gateway over Modbus-TCP to the ECC800 WebUI?
Prerequisites
The device supports DHCP.
Context
Figure 8-25 Network diagram
Procedure
Step 1 Ensure that the device communication mode has been set to DHCP.
Step 2 Log in to the ECC800 WebUI as an administrator, and check whether the device exists on the
Monitoring page.

Issue 05 (2019-09-16)
If the device exists, and communication status is normal, the device has accessed the
ECC800 successfully.
Figure 8-26 Device accessed the ECC800
Copyright © Huawei Technologies Co., Ltd.
8 FAQ
238