Huawei ECC800 User Manual page 216

ECC800 Data Center Controller
User Manual
Path
Choose System
Settings >
Device
Management
and click Add
Device. The
parameters for
adding devices
are displayed.
3.
4.
5.
Step 3 On the Running Parameters tab page, set smart cooling product running parameters.
Step 4 On the Controls tab page, set the smart cooling product control parameters (such as on/off
control parameters).
After the smart cooling product is shut down, the temperature of the smart module increases
and data running is affected. Exercise caution when performing this operation.
----End
Issue 05 (2019-09-16)
Parameter
Name
Device attribute
Device Type
Connect To
Communications
Port
Device Address
Click Test Connect to check whether the SUNRISE-SCU-20K connects to the ECC800
properly.
− If the SUNRISE-SCU-20K connects to the ECC800 properly, click Confirm. The
connected devices are displayed in the Number of connected devices list.
− If the SUNRISE-SCU-20K does not connect to the ECC800 properly, check
whether the cable between the SUNRISE-SCU-20K and the ECC800 is connected
properly, whether the SUNRISE-SCU-20K and ECC800 are running properly, and
whether the input parameters are consistent with the SUNRISE-SCU-20K
parameters.
Choose Monitoring > System > ETH Converter Group > ETH Converter n >
Running Parameters and set Device name to ETH Converter n_Device name.
Choose Monitoring > Cooling > SUNRISE-SCU-20K n > Running Parameters and
set Device name to SUNRISE-SCU-20K_Device name.
Copyright © Huawei Technologies Co., Ltd.
Setting
Select Air Conditioner from the drop-down list
box.
Select SUNRISE-SCU-20K from the drop-down
list box.
Select ETH Converter n from the drop-down list
box.
Select COM1/COM2 from the drop-down list box.
In this example, Device Address is set to 2. During
actual configuration, set the device address based
on the actual situation.
8 FAQ
206