Commissioning Event Notification - Huawei ECC800 User Manual

ECC800 Data Center Controller
User Manual

5.3 Commissioning Event Notification

You can set alarm notification by email or SMS as required. Information about a maximum of
20 users who will receive alarm notification can be displayed.
Prerequisites
To implement alarm notification by SMS, the following conditions must be met:

To implement alarm notification by email, the following conditions must be met:

Procedure
Step 1 Choose System Settings > Event Notification.
Step 2 Set related outbox parameters.
1.
2.
If Test email sending failed is displayed, check whether the receiver's email server requires
CA certificate verification. If it is required, download the CA certificate from the receiver's
email website and upload it in the Mailbox Certificate area.
Issue 05 (2019-09-16)
The ECC800 is configured with a 3G module and supports SIM card access in
2G/3G/4G mode. The 2G card should support the GSM mode, and the 3G/4G card
should support the WCDMA and GSM modes.
The ECC800 is connected to a network with an email server through a WAN port. Both
the Internet and local area network (LAN) are supported.
The ECC800 supports only SMS notification service but not data service by using the 3G module.
Set related parameters in the Outbox Settings area on the Mailbox Settings page. If the
address type of the outbox is Domain name, choose System Settings > System
Parameters, and set related parameters in the DNS Server Address area on the
Monitor IP page.
The DNS server address is provided by the local network operator.
Click Test to check the email sending. If an email fails to be sent, check the outbox
settings and DNS Server Address. If the email is sent successfully, click Submit.
Copyright © Huawei Technologies Co., Ltd.
5 Power-On Commissioning
90