How Should I Add Devices Accessed Through The Ecc800 Com Port To The Ecc800 Webui - Huawei ECC800 User Manual

ECC800 Data Center Controller
User Manual
4.
----End
Follow-up Procedure
Choose Home > Plan View on the ECC800 WebUI, and drag the device to the corresponding
position in the Smart Module View pane based on the actual device layout.
8.1.30 How Should I Add Devices Accessed Through the ECC800
COM Port to the ECC800 WebUI
Prerequisites
This section uses the device connecting to the COM1 port on the ECC800 as an example.
Context
Figure 8-30 Network diagram
Procedure
Step 1 Set communications parameters on the device.
Table 8-40 Description of communications parameters to be set on a device
Parameter
Baud rate
Communications address
Step 2 Add the device to the ECC800 WebUI.
Issue 05 (2019-09-16)
Choose Monitoring > System > ETH Converter Group > ETH Converter n >
Running Parameters and set Device name to ETH Converter n_Device name.
Copyright © Huawei Technologies Co., Ltd.
Recommended Value
This section uses 9600 as an example. Set this parameter
based on site requirements.
NOTE
For certain devices, this parameter does not need to be set.
This section uses 1 as an example. Set this parameter based on
site requirements.
8 FAQ
242