How Can I Add Devices Accessed Through The Ecc800-Pro Com Port To The Ecc800-Pro Webui - Huawei ECC800-Pro User Manual

ECC800 Data Center Controller
User Manual (for ECC800-Pro)
3.
4.
----End
Follow-up Procedure
Choose Home > Plan View on the ECC800-Pro WebUI, and drag the device to the
corresponding position in the Smart Module View pane based on the actual
device layout.
8.1.29 How Can I Add Devices Accessed Through the ECC800-
Pro COM Port to the ECC800-Pro WebUI?
Prerequisites
This section uses the device connecting to the COM1 port on the ECC800-Pro as
an example.
Issue 02 (2020-09-07)
Table 8-47 Parameter description for adding a device
Path Parameter
Choose Device
System attribute
Settings >
Device Type
Device
Management
and click Add
Connect To
Device. The
parameters
for adding
devices are
displayed.
Communicati
ons Port
Device
Address
Click Test Connect to check whether the device connects to the ECC800-Pro
properly.
– If the independent deployment AI_DI unit connects to the ECC800-Pro
successfully, click Confirm. The connected devices are displayed in the
Number of connected devices list.
– If the connection fails, check whether the device is properly connected to
the ECC800-Pro, whether the device and ECC800-Pro are running
properly, and whether the parameter settings are consistent with the
device parameters.
Choose Monitoring > System > ETH Converter Group > ETH Converter n >
Running Parameters and set Device name to ETH Converter n_Device
name.
Copyright © Huawei Technologies Co., Ltd.
Setting
Select the device attribute to be accessed
from the drop-down list box.
Select the device type to be accessed from
the drop-down list box.
Select the corresponding ETH converter
from the drop-down list box.
NOTE
Use the blinking function of the ETH converter
to identify the mapping between the device and
the ETH converter.
COM1/COM2
This section uses 1 as an example. In
practice, set this parameter to be the same
as the communications address for the
device.
8 FAQ
331