Huawei ECC800-Pro User Manual page 188

ECC800 Data Center Controller
User Manual (for ECC800-Pro)
Procedure
Step 1 Log in to the camera WebUI.
1.
2.
Step 2 For details about how to commission the camera and set parameters, see the
documents delivered with the device or the documents obtained by referring to
the "Preparing Documentation" section.
1.
2.
3.
4.
Issue 02 (2020-09-07)
Configure the PC IP address and the camera IP address in the same network
segment. Enter the camera IP address (192.168.0.120 by default) in the
address bar of the Internet Explorer and press Enter.
Enter the preset user name admin and the preset password HuaWei123, and
click Log In.
Preview the site situation in real time and check the camera coverage through
videos. Adjust the lens if necessary.
Set IPv4 address, IPv4 subnet mask, and IPv4 gateway address to the
planned values.
Figure 6-43 Setting the IP address of the camera
Format the SD card.
a. Choose Settings > System Configuration > Storage Management.
b. The Storage Management page is displayed. Format the SD card.
Set the camera stream type and primary stream parameters. Path: Settings >
Video/Audio/Image > Video Settings.
Copyright © Huawei Technologies Co., Ltd.
6 Feature Description
177