Huawei ECC800-Pro User Manual page 277

ECC800 Data Center Controller
User Manual (for ECC800-Pro)
1.
2.
3.
Step 2 Add a UPS5000.
1.
2.
3.
Issue 02 (2020-09-07)
On the displayed screen after UPS5000 startup, tap System Info.
Choose System Info > Settings, enter the user name admin and password
000001, and tap
Tap Communication and set RS485 baud rate to 9600, and RS485 address
to 1 on the displayed communication settings screen.
Figure 8-9 UPS5000 communication settings
Log in to the ECC800-Pro WebUI as an administrator.
Add a UPS5000.
Table 8-5 Adding a UPS5000.
Path Parameter
Choose Device
System attribute
Settings >
Device Type
Device
Management
and click Add
Connect To
Device. The
parameters
for adding
Communicati
devices are
ons Port
displayed.
Device
Address
Click Test Connect to check whether the UPS5000-E connects to the ECC800-
Pro properly.
– If the connection succeeds, click Confirm. The connected devices are
displayed in the Number of connected devices list.
Copyright © Huawei Technologies Co., Ltd.
.
Setting
Select UPS from the drop-down list box.
Select UPS5000 from the drop-down list
box.
Select ETH Converter n from the drop-
down list box.
Select COM1/COM2 from the drop-down
list box.
In this example, Device Address is set to 1.
During actual configuration, set the device
address for the UPS5000-E based on the
actual situation.
8 FAQ
266