Huawei ECC800-Pro User Manual page 127

ECC800 Data Center Controller
User Manual (for ECC800-Pro)
Address
3
4
Step 2 Check the eLight function.
Table 5-6 Function commissioning
Check Method
Choose Maintenance > Configuration
Wizard > Linkage Test > eLight
Controller Commissioning and click
Test.
Step 3 Set eLight parameters.
1. Log in to the ECC800-Pro WebUI as an administrator.
2. In the Smart Module View, click Modify Device. Select an eLight actuator
under Devices, drag it to the access actuator to which you want to bind the
eLight actuator, and click Exit Edit Mode.
Figure 5-9 eLight actuator position
Issue 02 (2020-09-07)
Toggle Toggle
Switch 1 Switch 2
ON ON
OFF OFF
Copyright © Huawei Technologies Co., Ltd.
5 Power-On Commissioning
Toggle
Switch 3
OFF
ON
Normal Connection Status
The eLight is lit up in red, green, blue,
and white in sequence for 3 seconds
respectively, and then turns off.
Toggle
Switch 4
OFF
OFF
116