Performing Startup Password Authentication (For Fusionmodule800) - Huawei ECC800-Pro User Manual

ECC800 Data Center Controller
User Manual (for ECC800-Pro)
2.
----End
5.2 Performing Startup Password Authentication (for
FusionModule800)
When the system type is FusionModule800, perform the following steps to
configure it.
Context
●
●
●
Issue 02 (2020-09-07)
Figure 5-3 WebUI login page
On the login page, enter the preset user name admin and preset password
Changeme, set the language, and click Log In.
NO TE
– After the first login, change the password in time to ensure account security and
prevent unauthorized network attacks, such as data tampering. Huawei will not be
liable for any security issues caused by your failure to change the preset password
in time or password loss after changing.
– Change the password of the user account periodically.
– Record and keep the password properly. If you forgot the password, you will be
unable to log in to the WebUI.
– When the event notification is configured and the password retrieval mode is
configured under user management, the password can be retrieved.
– An account is logged out due to timeout if no operation is performed within 10
minutes after system login.
– A maximum of three users can log in to the ECC800-Pro WebUI at the same time.
The initial startup password authentication is required only during initial
power-on commissioning. If the authentication has been performed
successfully, no authentication is required afterward.
The startup password needs to be authenticated when you restore the default
settings on the WebUI or by pressing keys.
If the startup password authentication is not complete, the ECC800-Pro
WebUI and app cannot be used for commissioning.
Copyright © Huawei Technologies Co., Ltd.
5 Power-On Commissioning
104