Networking Iboxs And Ibats In Wireless Mode - Huawei ECC800-Pro User Manual

ECC800 Data Center Controller
User Manual (for ECC800-Pro)
Table 6-43 Setting iBOX parameters
Parameter
iBOX single
battery qty.
Batt installation
time
Single battery
capacity
Current source
Battery string
No.
----End

6.9.2 Networking iBOXs and iBATs in Wireless Mode

Prerequisites
Before networking, ensure that all the iBOXs and iBATs have no network
parameters, that is, the RF_Z indicator on the iBOX is steady green and the
RUN/ALM indicator on the iBAT is steady red.
Context
●
●
Issue 02 (2020-09-07)
Description
Total number of batteries
monitored by the iBOX
Actual time at which batteries are
installed
Single battery capacity refers to the
capacity of a single battery in a
battery string managed by the
iBOX.
0–xxxA Hall
The actual specifications of the Hall
effect sensor prevail.
Set this parameter based on the
planned codes for iBOXs and
battery strings.
NO TE
● The iBAT is connected to the iBOX in RF_Z networking mode.
● If the RF_Z indicator on the iBOX is not steady on (green), press and hold down the
networking switch on the iBOX for 10–20 seconds to clear the original network.
● If the RUN/ALM indicator on the iBAT is not steady red, hold down the iBAT networking
switch for at least 5 seconds to clear the original network.
If multiple iBOXs are connected, commission the iBOX one by one in the same
way. Otherwise, networking may be in disorder.
Indicator status:
– Blinking at long intervals: The indicator is on for 1 second and then off
for 1 second alternately.
– Blinking at super short intervals: The indicator is on for 0.05 seconds and
then off for 0.05 seconds alternately.
Copyright © Huawei Technologies Co., Ltd.
6 Feature Description
Remarks
Set this parameter
based on the battery
parameter planned by
the customer.
-
Obtain the battery
capacity from the
battery label or
document.
-
Set this parameter
based on the
customer's plan.
212