Huawei ECC800-Pro User Manual page 280

ECC800 Data Center Controller
User Manual (for ECC800-Pro)
Procedure
5
6
7
Step 2 Add a transformer.
1.
2.
3.
----End
Issue 02 (2020-09-07)
Button
SET
SET
Log in to the ECC800-Pro WebUI as an administrator.
Add a transformer.
Table 8-6 Adding a transformer
Path Parameter
Choose Device
System attribute
Settings >
Device Type
Device
Management
and click Add
Connect To
Device. The
parameters
for adding
Communicati
devices are
ons Port
displayed.
Device
Address
Click Test Connect to check whether the transformer is properly connected to
the ECC800-Pro.
– If the connection succeeds, click Confirm. The connected devices are
displayed in the Number of connected devices list.
– If the connection fails, check whether the device is properly connected to
the ECC800-Pro, whether the device and ECC800-Pro are running
properly, and whether the parameter settings are consistent with the
device parameters.
Copyright © Huawei Technologies Co., Ltd.
Display Description
1: address
Set this
parameter as
required.
The temperature controller exits the
communication address setting state and
returns to the temperature display state.
Setting
Select Transformer from the drop-down
list box.
Select Transformer_LD-B10 from the
drop-down list box.
Select ECC800 from the drop-down list
box.
Select COM1 from the drop-down list box.
In this example, Device Address is set to 1.
During actual configuration, set the device
address for the transformer based on the
actual situation.
8 FAQ
Range
/
1–247
269