How Should I Add The Devices Accessed Through A Smart Eth Gateway Over Modbus-Tcp To The Ecc800 Webui - Huawei ECC800 User Manual

ECC800 Data Center Controller
User Manual
9.1.19 How Should I Add the Devices Accessed Through a Smart
ETH Gateway over Modbus-TCP to the ECC800 WebUI?
Prerequisites
The device supports DHCP.
Context
Figure 9-3 Network diagram
Procedure
Step 1 Ensure that the device communication mode has been set to DHCP.
Step 2 Log in to the ECC800 WebUI as an administrator, and check whether the device exists on the
Monitoring page.


----End
Issue 02 (2019-02-28)
If the device exists, and communication status is normal, the device has accessed the
ECC800 successfully.
Figure 9-4 Device accessed the ECC800
If the device does not exist, check that the cable is properly connected between the
device and the ECC800, the ECC800 is operating properly, and communications
parameters are set correctly.
Copyright © Huawei Technologies Co., Ltd.
9 FAQ
208