Setting And Adding An Ats - Huawei ECC800 User Manual

ECC800 Data Center Controller
User Manual
Table 5-10 Power distribution settings for a power distribution unit
Path
Monitoring >
Power
Distribution >
Power
Distribution
Unit 1 >
Running
Parameters >
Power
Distribution
Settings
4.
----End

5.3.13 Setting and Adding an ATS

Prerequisites
An ATS (automatic transfer switch) has connected to the COM port on the ECC800.
Context
After replacing an ATS or an ECC800, add an ATS on the ECC800 WebUI.
Procedure
Step 1 Set the ATS device address. On the ATS display panel, choose Device Configuration >
Modbus and set the device address.
Step 2 Add an ATS.
1.
2.
Issue 02 (2019-02-28)
Parameter Name
QF1 Rated current (QF1)
QF2 Rated current (QF2)
QF1 Branch circuit breaker in
use (QF1)
QF2 Branch circuit breaker in
use (QF2)
Set the parameters for other power distribution units in the same way or by
synchronizing parameters.
Choose Maintenance > Parameter Sync.
 The ATS device address is 1 by default.
 The initial password is 0001 for the ATS display panel.
Log in to the ECC800 WebUI as an administrator.
Add an ATS.
Copyright © Huawei Technologies Co., Ltd.
5 Power-On Commissioning
Default Description
Value
32 Rated current 32 A for
each branch. The value
ranges from 0 to 100.
Enable When the parameter is
set to Disable for a
branch, all alarms of the
branch will not be
reported.
When the parameter is
set to Enable for a
branch, all alarms of the
branch will be reported.
107