Setting And Adding An Ats - Huawei ECC800 User Manual

ECC800 Data Center Controller
User Manual
Table 5-6 Setting PDU8000 parameters
Path
Home >
Equipment
Management
3.
----End

5.3.10 Setting and Adding an ATS

Prerequisites
An ATS (automatic transfer switch) has connected to the COM port on the ECC800, and the
ATS and ECC800 are powered on.
Context
After replacing an ATS or an ECC800, add an ATS on the ECC800 WebUI.
Procedure
Step 1 Setting the ATS device address. On the ATS display panel, choose Device Configuration >
Modbus and set the device address.
Step 2 Add an ATS.
1.
2.
Issue 06 (2020-01-02)
Parameter
Name
Device type
Connect to
Communications
port
Device address
Click Connect Test to check whether the PDU8000 connects to the ECC800 properly.
If the PDU8000 connects to the ECC800 properly, click Add Device.
−
If the PDU8000 does not connect to the ECC800 properly, check whether the cable
−
between the PDU8000 and the ECC800 is connected properly, whether the
PDU8000 and ECC800 are running properly, and whether the input parameters are
the consistent with the PDU8000 parameters.
 The ATS device address is 1 by default.
 The password is 0001 by default.
Log in to the ECC800 WebUI as an administrator.
Add an ATS.
By default, an ATS is connected to port COM1 on the ECC800. If the ATS is connected
to another port, set the COM port to the ECC800 port connected to the ATS.
Copyright © Huawei Technologies Co., Ltd.
Setting
Select PDU8000 from the drop-down list box.
Select ECC800 from the drop-down list box.
Select COM2 from the drop-down list box.
In this example, set Device address to 1. Set the
actual device address of the PDU8000 during
operations.
5 Power-On Commissioning
101