Huawei ECC800 User Manual page 148

ECC800 Data Center Controller
User Manual
If multiple cameras are accessed, retain the connection of one camera and disconnect
connections from other cameras. After commissioning the connected camera, commission
other cameras in the same way.
Context
The current network is configured with an ECC800 and supports the function of DHCP
(Dynamic Host Configuration Protocol). In the network, the IPC6325 camera automatically
obtains an IP address in the same IP address segment as the ECC800 after the ECC800 and
IPC6325 are powered on. Therefore, you need to reset the IPC6325 camera IP address before
commissioning an IPC6325 camera.
Procedure
Step 1 Reset the IPC6325 camera IP address.
1.
2.
3.
4.
5.
6.
7.
Step 2 Set camera parameters and commission the camera according to the document delivered with
the camera.
1.
2.
3.
4.
Issue 06 (2020-01-02)

If the communications cable between the smart ETH gateway and the ECC800 is disconnected
before the camera is powered on for the first time, the camera IP address is not automatically
allocated by the ECC800. Therefore, you do not have to perform
 If the VCN500 is configured, obtain a dynamic IP address (192.168.248.XX, for example) for the
camera by selecting Adding Cameras Using a Wizard on the C/S client, and then log in to the
camera WebUI using the dynamic address and perform
Disconnect the communications cable between the smart ETH gateway and the ECC800.
Press the Reset button on the camera to restore the camera IP address to the factory
default.
Use a network cable to connect the PC to an idle network port on the smart ETH
gateway. Set the PC IP address and camera IP address (192.168.0.120 by default) in the
same network segment.
Enter the camera IP address (192.168.0.120 by default) in the address bar of the Internet
Explorer and press Enter button.
Enter the preset user name admin and the preset password HuaWei123, and click Log
In.
Choose Settings > Network Configuration > Network Parameters and set the camera
IP address to 192.168.248.50.
Set IP address to 192.168.248.50, Subnet mask to 255.255.255.0, and Gateway IP address to
192.168.248.1. The values here are examples. The actual values prevail.
Reconnect the communications cable between the smart ETH gateway and the ECC800.
Set the PC IP address and camera IP address (192.168.248.50) in the same network
segment, and log in to the camera WebUI again.
Preview the site situation in real time and check the camera coverage through videos.
Adjust the lens if necessary.
(Optional) If you use the SD card when no VCM500 is configured, set Video Plan and
enable the plan. To ensure sufficient storage capacity of the SD card, you are advised to
enable the motion detection function on the camera WebUI.
Set camera stream type, primary stream, and secondary stream 1 parameters.
Copyright © Huawei Technologies Co., Ltd.
5 Power-On Commissioning
Step 1.1 and Step
Step 1.6.
1.2.
139