Remote Management; Neteco Management; Connecting The Communications Cable; Setting Neteco Parameters - Huawei ECC800 User Manual

ECC800 Data Center Controller
User Manual

6.1 NetEco Management

6.1.1 Connecting the Communications Cable

6.1.2 Setting NetEco Parameters

When the smart module can be connected to the NetEco, perform the following steps to
configure parameters.
Procedure
Step 1 Apply for a fixed IP address to the equipment room network administrator.
Step 2 Set the IP address, subnet mask, and default gateway on the ECC800 WebUI.
Table 6-1 IP parameters
Path Parameter
IP
System
Settings >
Monitor
Subnet Mask
Module IP >
WAN_1
Default
Gateway
Step 3 Set NetEco communications parameters on the ECC800 WebUI.
Table 6-2 NetEco parameters
Path
System Settings >
NetEco >
Issue 06 (2020-01-02)
Default Value
192.168.1.10
255.255.255.0
192.168.1.1
Parameter Default
Value
Primary Server IP 192.168.0.10
Copyright © Huawei Technologies Co., Ltd.
6

Remote Management

Setting
Set this parameter based on the IP address assigned
by the network administrator.
Set this parameter based on the subnet mask assigned
by the network administrator.
Set this parameter based on the default gateway
address assigned by the network administrator.
Setting
IP address of the active NetEco server
NOTE
6 Remote Management
150