Creating A Micro-Module Plan View - Huawei ECC800 User Manual

ECC800 Data Center Controller
User Manual

5.4 Creating a Micro-module Plan View

Prerequisites
To create a micro-module plan view, it is recommended that you obtain or draw the planned
layout of the micro-modular data center before the creation.
Context
The system types are FusionModule2000, FusionModule800, FusionModule1000B.
Procedure
Step 1 Choose Home > Plan View, and click Create Micro-Module in the Micro-Module View,
and set the layout and device quantity based on the actual micro-module scenario.
Step 2 Drag the icons of registered devices (for example, the WiFi converter and smart ETH gateway)
and devices on the cabinet list to appropriate positions in the layout to create a micro-module
plan view.
Step 3 Hold down the BLINK button on a device (such as a smart ETH gateway) for less than 1s to
report the blinking status to the ECC800. The corresponding device icon in the WebUI plan
view blinks. You can also drag a device on the ECC800 WebUI to report the blinking status
to the device. Check that the device positions and types in the plan view are consistent with
the actual situation by delivering the blinking command.
Figure 5-10 Micro-module Plan View
Step 4 Modify the micro-module view.
1.
Issue 06 (2020-01-02)
The figure shows the FusionModule2000 scenario. The actual WebUI depends on the scenario.
Choose Home > Plan View.
Copyright © Huawei Technologies Co., Ltd.
5 Power-On Commissioning
118