Huawei ECC800 User Manual page 42

ECC800 Data Center Controller
User Manual
Indicato
r
RUN
ALM
RF_Z
Issue 06 (2020-01-02)
Color Name
Green Communication
status indicator
Red Alarm indicator
Green Wireless
communication
status indicator
Copyright © Huawei Technologies Co., Ltd.
Status Description
Off The power is abnormal or the
board program is loading.
Blinking at The access actuator
long intervals successfully registers with the
ECC800 and the software runs
properly (the indicator blinks
at 0.5 Hz, on for 1s and then
off for 1s).
Blinking at The communication is
short intervals
disconnected or the access
actuator fails to register with
the ECC800 (the indicator
blinks at 4 Hz, on for 0.125s
and then off for 0.125s).
Blinking The indicator blinks at super
short intervals for 0.5s
(blinking at 10 Hz, on for
0.05s and then off for 0.05s)
and then turns off for 0.5s. The
cycle lasts for 10s.
Steady on A system failure alarm is
generated.
Off No system alarm is generated.
Steady on No network parameters exist,
or a network is to be created.
Blinking at A network is set up, and no
long intervals
node access is allowed (the
indicator blinks at 0.5 Hz, on
for 1s and then off for 1s).
Blinking at A network is set up, and node
super short access is allowed (the
intervals
indicator blinks at 10 Hz, on
for 0.05s and then off for
0.05s).
Blinking The access actuator is
intermittently searching for a network (the
at super short indicator blinks at super short
intervals intervals for 0.5s and then
turns off for 0.5s).
3 Device Description
33