Adding A Camera On The Vcn500 - Huawei ECC800 User Manual

ECC800 Data Center Controller
User Manual
Step 2 Preview the site situation in real time and check the camera coverage through videos. Adjust
the lens if necessary.
Step 3 (Optional) If you use the SD card when no VCM500 is configured, set Video Plan and enable
the plan. To ensure sufficient storage capacity of the SD card, you are advised to enable the
motion detection function on the camera WebUI.
Step 4 Set video parameters.
Figure 5-24 Setting video parameters
Step 5 Choose Configuration > Basic Configuration > Network, and set the camera IP address
according to the site requirements.
----End

5.11.4 Adding a Camera on the VCN500

Prerequisites
The network communication between the VCN500 and the camera is normal.
Procedure
Step 1 Install Client/Server (C/S) client.
Issue 06 (2020-01-02)
Set IPv4 Address to 192.168.248.50, IPv4 Subnet Mask to 255.255.255.0, and IPv4 Default Gateway
to 192.168.248.1. The values here are examples. The actual values prevail.
The version number is subject to the Quick Start delivered with the VCN500. The description and link in
this document are for reference only.
Copyright © Huawei Technologies Co., Ltd.
5 Power-On Commissioning
142