Commissioning Sensors; Commissioning A Multi-Functional Sensor - Huawei ECC800 User Manual

ECC800 Data Center Controller
User Manual
Table 5-23 Function commissioning
Check Method
Path: Monitoring > Aisle > AC Actuator Group >
AC Actuator > Controls
1. Choose Running Parameters, set Set light mode
2. Choose Controls, select Light control, select
----End
Follow-up Procedure
Set Set light mode is Automatic.

5.9 Commissioning Sensors

5.9.1 Commissioning a Multi-functional Sensor

If a multi-functional sensor is installed, perform the following steps to configure it.
Procedure
Step 1 Set multi-functional sensor parameters.
On the WebUI, choose Monitoring > Aisle > Multi-Func Sensor Group > Multi-Func
Sensor1 > Running Parameters, ensure that Smoke enable and Temp enable are set to
Enable, set High temperature alarm threshold and other parameters as required, and then
click Submit.
Step 2 Check the functions of the multi-functional sensor.
Table 5-24 Function commissioning
Check Method
Temperature and humidity detection: View
the running information about the
multi-functional sensor on the WebUI.
Smoke detection: Simulate a smoky
environment.
Smoke generation methods:

Issue 06 (2020-01-02)
is Manual.
ON, and click Submit.
Inhale cigarette smoke deeply. Then spit
out all smoke at the corner nearest to the
ALM indicator, that is, 5–10 cm away
from the smoke compartment, and let
smoke enter the smoke compartment
through the hole in the side of the
Copyright © Huawei Technologies Co., Ltd.
5 Power-On Commissioning
Normal Connection Status
The light is on.
Normal Connection Status
You can view the current ambient
temperature and humidity.
 Start counting time immediately when
smoke is entering the hole. After about
30 seconds, the red ALM indicator
turns on, and the app or WebUI
displays a smoke sensor alarm.
 Some time later after the smoke is
dispersed, the red ALM indicator turns
off and the smoke sensor alarm
disappears.
124