Commissioning An Ac Actuator - Huawei ECC800 User Manual

ECC800 Data Center Controller
User Manual
Figure 5-13 Sender's email settings
Step 3 Click Add in Alarm Notification User Info.
Step 4 Set Notification language, enter values for Email address and Mobile number, and set
Alarm severity. Click Test to test whether the short message is sent successfully. If the short
message fails to be sent, check the email and mobile phone parameter settings; if the short
message is sent successfully, click OK.
Figure 5-14 Adding alarm notification user information
Step 5 Click OK and the re-authentication page is displayed. Enter Login password and click
Submit.
----End
Follow-up Procedure
To modify or delete the email parameter settings, click Modify or Delete button, the
re-authentication page is displayed. Enter Login password and click Submit.

5.8 Commissioning an AC Actuator

If an AC actuator is installed, perform the following steps to configure it.
Issue 06 (2020-01-02)
Select a notification level. If Warning is selected, then all alarms at the Warning level or higher will be
sent to the email address specified by Email address by email or to the phone number specified by
Mobile number by SMS.
Copyright © Huawei Technologies Co., Ltd.
5 Power-On Commissioning
122