Huawei ECC800 User Manual page 162

ECC800 Data Center Controller
User Manual
Context


Procedure
Step 1 Apply to the equipment room network administrator for a fixed IP address.
Step 2 Set the IP address, subnet mask, and default gateway on the ECC800 WebUI.
Table 6-4 IP parameters
Path Item
System IP
Settings >
Monitor
Subnet mask
Module IP >
WAN_1
Default gateway
Step 3 Set SNMP parameters.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. After setting the parameters, click Confirm.
Issue 06 (2020-01-02)
SNMPv3 parameters should be set before connecting the ECC800 to the NMS. These
parameters are required for setting up the ECC800 on the NMS.
SNMPv1 and SNMPv2c are insecure. Therefore, SNMPv3 is recommended. This
section uses SNMPv3 as an example.
Default Value
192.168.1.10
255.255.255.0
192.168.1.1
Choose System Settings > SNMP Settings.
Set SNMP version to SNMPv3 and set SNMP port number to the required port
number or retain its default value 161.
Click Submit under SNMP.
Click Add in SNMPv3.
Set User name, set Authentication protocol to SHA or MD5, set Privacy protocol to
AES or DES, and specify MD5/SHA password, Confirm MD5/SHA password,
DES/AES password, and Confirm DES/AES password.
 Set User name, MD5/SHA password, and DES/AES password to any character strings that meet
the system requirements. Note that MD5/SHA password and DES/AES password must be set to
different values. Record the settings.
 MD5 and DES are insecure protocols. Therefore, you are advised to set Authentication protocol to
SHA or set Privacy protocol to AES.
Set Password validity period and Advance expiration notification (days).
After setting the parameters, click Confirm.
Click Add under SNMP Trap.
Set Trap target address and Trap port, set SNMP version to SNMPv3, and specify
SNMPv3 user name. Set Trap target address to the IP address of the NMS server and
set Trap port to the port defined by the user.
Copyright © Huawei Technologies Co., Ltd.
Setting
Set this parameter based on the IP address assigned
by the network administrator.
Set this parameter based on the subnet mask assigned
by the network administrator.
Set this parameter based on the default gateway
address assigned by the network administrator.
6 Remote Management
153