Adding A Networked Device - Huawei ECC800 User Manual

ECC800 Data Center Controller
User Manual

5.3.23 Adding a Networked Device

Prerequisites


Context


Procedure
Step 1 Log in to the ECC800 WebUI as an administrator.
Step 2 Choose Monitoring > System > ECC800 > Running Parameters.
Step 3 On the Online Detection Timeout Interval tab page, set Online detection timeout interval
to 29. The value range is 10 to 60 seconds.
Step 4 On the Site Device Number tab page, set Site device num to 5. The value range is 0 to 100.
Step 5 Click Submit. The Site Device 1-5 tab page is displayed.
Step 6 On the Site Device 1-5 tab page, set Enable online detection 1 to Enable.
Step 7 Click Submit.
Step 8 Specify Device address 1 and Device name 1.
Step 9 Click Submit.
----End
Issue 06 (2020-01-02)
A networked device is connected to the ECC800 over a switch. The device and ECC800
have been powered on.
You have obtained the IP address of the networked device.
Networked devices, such as ATMs, are devices with IP attributes in an equipment room
or site. By adding a networked device, you connect the device to the ECC800 in the
same network so that the ECC800 monitors the device status. If the networked device is
offline, the ECC800 will report a disconnection alarm on its WebUI.
Following is a procedure example about how to add five networked devices with the
online detection timeout interval being 29 seconds.
Online detection timeout interval is 30 by default, which means that the ECC800 determines that the
communication with the device is interrupted if the device has no response within 30 seconds.

Set Device address 1 to the IP address of networked device 1 and Device name 1 to the name of
networked device 1. For example, set Device address 1 to XXX.XXX.X.XXX and Device name 1
to No. X ATM in the XXX site.
 Add other networked devices in the same way.
Copyright © Huawei Technologies Co., Ltd.
5 Power-On Commissioning
117