Huawei ECC800 User Manual page 148

ECC800 Data Center Controller
User Manual
2.
3.
4.
5.
Issue 02 (2019-02-28)
Click Add to enter the page for adding permissions.
Click and select the user whose access permissions need to be set, and set the Door,
Authorization mode, Cabinet lock, and the permission validity period.
− Door: Select the authorized access actuator for the user based on the actual
requirements. For example, select Access Actuator1 or Access Actuator2 on the
Door tab.
− Authorization mode: Select Card, Fingerprint, Card and password, Card and
fingerprint, Fingerprint and password, or Card, password and fingerprint.
For example, if you select Card, password and fingerprint for the authorization mode, the door can be
opened only after you swipe an authorized card first, enter the authorized password (press # to confirm
the password), and then scan the fingerprint.
− Cabinet lock: Select a type on the Cabinet Lock tab, for example, Smart module >
IT Cabinet1 > E–LOCK1.
− Permission validity period: Set Start date, Expiration date, and Allow door open
period.
You do not have to set a validity period for the cabinet lock.
An authorized IC card can be used to open both the access control device and the cabinet magnetic lock.
Figure 5-16 Adding access permissions
In the displayed prompt box, click OK.
Click Synchronize Permission, select the modified access control devices, and click
Start Synchronization.
Copyright © Huawei Technologies Co., Ltd.
5 Power-On Commissioning
139