Commissioning The Elight (For Fusionmodule800) - Huawei ECC800 User Manual

ECC800 Data Center Controller
User Manual (for ECC800-Pro)
Item
NOTE

5.7 Commissioning the eLight (for FusionModule800)

When the system type is FusionModule800 an eLight is installed, perform the following steps
to configure it.
Procedure
Step 1 Ensure that the device address of the eLight actuator is the default value 2.
Toggle switches 1 to 4 of the DIP switch specify the device address in binary mode. ON
indicates 1, and OFF indicates 0.
Table 5-9 Setting a device address
Address
1
2
3
4
Step 2 Add an eLight.
1.
2.
Issue 06 (2020-04-22)
Alarm Severity
Selection
Critical, Major, Minor
Critical, Major,
Minor, Warning
None
After you set the alarm severity, the eLight indicator is off if no alarm is generated.
Toggle
Switch 1
ON
OFF
ON
OFF
Log in to the ECC800-Pro WebUI as an administrator.
Add an eLight.
Copyright © Huawei Technologies Co., Ltd.
Description
strip light preferentially turns on with a
light corresponding to the high-severity
alarm. After the high-severity alarm is
cleared, the eLight strip light turns on
with a light corresponding to the
low-severity alarm.
NOTE
 Critical: red light
 Major: orange light

Minor: yellow light

Warning: white light
The eLight strip light is steady blue
(atmosphere light).
Toggle Toggle
Switch 2 Switch 3
OFF OFF
ON OFF
ON OFF
OFF ON
5 Power-On Commissioning
Toggle
Switch 4
OFF
OFF
OFF
OFF
107