c)
When storing the controller in a rack, be sure to configure so that the weight of the
controller can be supported by the legs of the controller. The controller's rack
mount screw holes are provided to fasten the controller panel and thus the weight
of the controller cannot be supported with these only.
d)
On the front of the controller, a clearance of approx. 90 mm should be provided for
connecting the connector of the teach pendant. Even if the teach pendant is not
used, a clearance of approx. 60 mm is required for connecting a dummy plug.
TRANSPORTATION AND INSTALLATION MANUAL
Fig. 2.28 Removing upper cover
– 49 –
STE 85389