Section 4 Tool Interface; Mounting Tool - Toshiba TH180 Instruction Manual

TRANSPORTATION AND INSTALLATION MANUAL

Section 4 Tool Interface

4.1

Mounting Tool

a) TH250A, TH350A, TH180 and TH350A‐ T
The tool is mounted on the end of the tool shaft (ø16). The tool shaft has a dog
for the stopper, and the section in front of the dog is used for mounting the tool.
At this time, the dog should not be removed. Dimensions of the tool shaft
section are shown in Fig. 4.1 (a).
As shown in Fig. 4.1, the tool is secured to the tool shaft with split clamp. As
there is not a reference such as keyway on the tool shaft, however, take care of
the tool direction when mounting.
φ35
Stopper dog
0
φ16-0.018
Tool shaft
(a) Dimensions of tool shaft section
STE 85389
– 69 –