Setting Station Id Modes; Figure 7-17: Infrastructure Command Groups-Set Station Mode Id - Motorola RF-Conductor! 3200 Manual

Site Encoding Commands

Setting Station ID Modes

This command is used to set station ID mode. The Mode parameter has two options: Auto,
and Substitute.
1. From the Site Encoding screen, use the
Set Station ID Mode
Figure 7-17: Infrastructure Command Groups—Set Station Mode ID
The select station ID mode screen appears with two options (see Figure 7-18):
– Auto
– Substitute
The default Station ID Mode is Substitute. If the mode is changed to Auto, then the
station ID is transmitted at an interval programmed at the transmitter.
7-18
<tab>
and press: (see Figure 7-17).
<Return>
6880494G55-O
RF-Conductor! Controller NIU Remote Configuration
to position the cursor to the left of the listing
May 1998