Table of Contents
Advertisement
RF-Conductor! Controller NIU Remote Configuration
Basic RF-C! Controller Instructions
Three login levels are provided by the RF-C! controller software to use the WMS-Data
operator console:
•
Administrator
•
Viewer
•
Site Operator
The Administrator and Viewer levels provide the capability to display all status and event
logs. The viewer level provides read-only access to RF-C! controller screens. The administrator
level provides the capability to change all configurable parameters and execute commands to
perform functions such as resynchronization, maintenance cycles, and changing passwords.
The Site Operator level allows users to execute a specific set of commands to control and
monitor a set of transmitters.
To use the Infrastructure Commands menu, you must have Administrator access. Refer to the
System Administration manual (
6880494G54) for information on setting your access level.
Setting up Passwords
The first-time RF-C! controller user, either as an administrator, viewer, or site operator, is
prompted to set up a password. Once the initial password is set up for each type of user, the
password prompt does not display. After logging in, the administrator has the ability to
change passwords.
The RF-C! controller has the capability to maintain one administrator password, one viewer
password, and one site operator password. It is important to remember the selected
passwords to access the RF-C! controller.
The password can be any number of alphanumeric characters up to 20 characters in length.
However, it is suggested to select a password of approximately 8 characters.
Note:
If the Esprit 5055 Video Display Terminal (VDT) is not configured for use with the RF-C!
controller software, or the VDT parameters need to be verified, see Appendix A, "Configuring
the Esprit 5055 Video Display Terminal".
May 1998
RF-Conductor! Operation and Software Installation,
6880494G55-O
Introduction
1-5
Advertisement
Table of Contents
