Table of Contents
Advertisement
SuperStream Commands
Changing Link Parameters
This command sets the link type, the data rate of the SuperStream link, and the Stream ID. All
transmitters that are on the same link must have their data rate set to the same value.
1.
From the SuperStream menu, use the
Change Link Parameters
Figure 4-11: SuperStream Menu—Change Link Parameters
The Select Change Stream ID screen appears.
2.
Position the cursor to select Yes or No and press:
the Stream ID, select No.
The Select Link Speed screen appears.
4-12
RF-Conductor! Controller NIU Remote Configuration
to position the cursor to the left of the listing
<tab>
and press:
(see Figure 4-11).
<Return>
6880494G55-O
. If you don't want to change
<Return>
May 1998
Advertisement
Table of Contents
