Battery; Buffering - Siemens SITOP UPS1600 Equipment Manual

Engineering and remote access
3.10 OPC UA server
Display name Data type
AlarmLow Boolean
VoltageMode
AlarmNoCharging Boolean
ManualDeactivated
AlarmOutputTurnedOff Boolean
AlarmOutputTurnedOn Boolean
AlarmOverCurrent Boolean
AlarmResetExecuted Boolean
AlarmSurplusBattery Boolean
AlarmUnknownBattery Boolean
AlarmWrongBattery Boolean
Polarity
3.10.6.8

Battery

Display name Data type
BatteryCapacity Float
Setpoint
BatteryDefectVoltage Float
Setpoint
BatteryIgnoreCoding Boolean
Setpoint
BatteryInspection Byte
TimeSetpoint
3.10.6.9

Buffering

Display name Data type
BufferExpected Float
CurrentSetpoint
BufferThreshold Float
Setpoint
BufferTime2Setpoint UInt16
BufferTimeSetpoint UInt16
BufferingEnableSet- Boolean
point
170
Definition Description
PropertyType Input voltage of SITOP UPS1600 is too low. The buffer of the
SITOP UPS1600 is not operational.
PropertyType Charging function was deactivated by a control command
PropertyType Output of SITOP UPS1600 has been switched off due to the
execution of a command or because an error situation has
occurred (e.g. temperature or output current too high).
PropertyType Output of SITOP UPS1600 has been switched on again due
to the execution of a command or because an error situation
has been remedied.
PropertyType Output current of SITOP UPS1600 is too high. Output is
switched off for 20 s. The output is switched on again after
20 s.
PropertyType Input voltage connected to SITOP UPS1600 was already OK
before the buffer time expired. Connected devices are reset
by switching off the SITOP UPS1600 outputs for the parame-
terized time.
PropertyType More than 6 batteries are connected. Connect max. of
6 batteries to the Energy Storage Link.
PropertyType Data from the battery cannot be read correctly. Battery is
defective or not supported by SIEMENS.
PropertyType Wrong battery polarity - check battery connections.
Definition Description
AnalogItemType Total battery capacity in Ah
AnalogItemType If battery voltage is lower than this value, the battery is con-
sidered defective.
PropertyType When this parameter is set to '1', data from the coded bat-
tery is ignored. The data is taken from the parameter as-
signment in this case.
PropertyType Battery test interval in hours
Definition Description
AnalogItemType Estimated average output current during buffer mode
PropertyType Trigger voltage for buffering - buffering is activated below
this value
AnalogItemType Additional buffer time after PC shutdown (valid only in con-
junction with SITOP Manager)
AnalogItemType Desired buffering time before device switches off
PropertyType Enable buffering
SITOP UPS1600 / BAT1600 / UPS1100
Equipment Manual, 07.2021, A5E37775406-11-76