Parameterizing The Ups1600 - Siemens SITOP UPS1600 Equipment Manual

Engineering and remote access
3.4 SIMATIC STEP 7 in the TIA Portal
3.4.7

Parameterizing the UPS1600

The adjustable parameters of the SITOP UPS1600 can be found in STEP 7 in the TIA Portal in
the inspector window under Properties when the appropriate device was selected.
For parameterization, in the area navigation, the settings under "Device configuration" ("Base
Unit", "Energy storage") and "Web server" are relevant.
Navigation area
Device configu- Base Unit
ration
Energy storage
Navigation area
Web server General
Automatic update
Navigation area
OPC UA server General
Security Policies
Navigation area
NTP client NTP client activat-
ed
NTP server
Address 1 ... 4
70
Description
Buffering All parameters, which involve the behavior of SITOP
UPS1600 when buffering
Signaling Setting of the alarm signaling and the wait time for stable
input voltage.
Charging Charging the battery
- Parameters for the battery modules used
Description
Defines whether it is permissible to access SITOP UPS1600 via the web server
(yes / no)
Activate the web server on this module
Activate automatic logoff
Access only via HTTPS
Activate automatic update
Activation interval
Description
OPC UA Server activat- Here, activate the OPC UA server.
ed
OPC UA server port Specify which port should be used.
Activation of anony-
mous access
No security If the option is activated, then unencrypted access via the
OPC UA client is possible. Activating the option is not
recommended.
Basic128 - Sign & En- Allow Basic128 security profile for OPC UA communica-
crypt tion.
Basic256 - Sign & En- Allow Basic256 security profile for OPC UA communica-
crypt tion.
Basic256Sha256 - Sign Allow Basic256Sha256 security profile for OPC UA com-
& Encrypt munication.
Description
Here, activate the NTP client.
Enter up to 4 addresses for an NTP server.
SITOP UPS1600 / BAT1600 / UPS1100
Equipment Manual, 07.2021, A5E37775406-11-76