Device Configuration - Siemens SITOP UPS1600 Equipment Manual

Navigation area
PROFINET securi- DCP write protec-
ty tion activated
A detailed description of the individual parameters of the subgroups is contained in the
associated section under Parameterizing the UPS in STEP 7 in the TIA Portal (Page 70).
The procedure is the same for all parameters. This section describes the general procedure to
reach the configuration dialog, using as example the parameters for buffering. The individual
parameters and their possible values are described in the following subsections.
Each parameter has a start value. A click on "Reset to initial values" resets all parameters of a
subgroup to the associated start value.
Preconditions
• The SITOP UPS1600 was integrated in the opened project.
Procedure
1. Select the SITOP UPS1600 in the Device view.
2. In the inspector window select "Properties > General > Device configuration".
Entries for parameterization are provided in the navigation area.
3.4.7.1

Device configuration

Base Unit
SITOP UPS1600 / BAT1600 / UPS1100
Equipment Manual, 07.2021, A5E37775406-11-76
Description
Activate or deactivate write protection for configuration changes via the DCP proto-
col
Engineering and remote access
3.4 SIMATIC STEP 7 in the TIA Portal
71