Panasonic DBS Series Programming Manual page 100

Panasonic Digital Business System - Programming Manual
April 1997
Hunt Group Member No Answer Timer
Select the no answer time for extension in the specified hunt group to enable No Answer hunting.
No Answer hunting uses 2 timers; a member no answer timer and a group no answer timer. This
mode of hunting can be used with terminate, circular or cyclic hunt groups.
An incoming call will ring for the duration of the member no answer timer and if unanswered,
move on to the next member and restart the timer. This will continue for the duration of the group
no answer timer. When the group no answer timer elapses the hunt will move onto the next
designated hunt group and continue hunting according to the new group's settings.
If the member no answer timer is set to 0, the busy hunting mode will be used ( the hunting mode
used in software levels up to v4.x and ISDN 1.x ).
If all members are busy the call will wait at the extension it was directed to until the member no
answer timer elapses at which point it will hunt again.
FF4 4# (1-24)# 35# (0-15)#
(1-24)#
Hunt Group
(0-15)#
0# Busy Hunting
1# 4 sec
2# 8 sec
3# 12 sec
4# 16 sec
5# 20 sec
6# 24 sec
7# 28 sec
8# 32 sec
9# 36 sec
10# 40 sec
11# 44 sec
12# 48 sec
13# 52 sec
14# 56 sec
15# 60 sec
100
Issue 15
CPC-EX 1.0