Panasonic DBS Series Programming Manual page 94

Panasonic Digital Business System - Programming Manual
April 1997
Analogue extension time break recall time
0#: Less than 20 ms
1#: Less than 20 ms
2#: Less than 20 ms
3#: Less than 20 ms
4#: Less than 20 ms
5#: Less than 20 ms
6#: Less than 20 ms
7#: Less than 20 ms
8#: Less than 20 ms
9#: Less than 20 ms
10#: Less than 20 ms
11#: Less than 20 ms
12#: Less than 20 ms
This sets the time break recall time for analogue extensions. This step is useful to match the time
break recall time generated by connected analogue equipment if problems are encountered using
recall. The default setting is suitable for the majority of installations. This step has no effect on the
operation of digital extensions.
System speed dial (SSD) group selection
1#: SSD group 1
2#: SSD group 2
This specifies which group of system speed dials the extension has access too. The SSDs are
divided into two groups of 90 numbers. Each extension can have access to either group 1 or group
2.
Extension tenant group setting
1#: Tenant No.1
2#: Tenant No.2
3#: Tenant No.3
4#: Tenant No.4
5#: Tenant No.5
6#: Tenant No.6
7#: Tenant No.7
8#: Tenant No.8
This is specifies the tenant group number for each extension. A tenant group is a sub group of
lines available to line group 0. When '9' is dialled, a free line from the designated tenant group is
seized automatically.
Related steps FF2 1# (01-48)# 3# , Line group assignment - group 0
FF2 1# (01-48)# 25# , Exchange line tenant group setting
FF3-(001-144)#-34#-(0-13)#
200-500 ms over 500 ms
200-750 ms over 750 ms
200-1000 ms over 1000 ms
200-1200 ms over 1500 ms
200-1500 ms over 200 ms
over 200 ms
30-150 ms over 200 ms
60-150 ms over 200 ms
65-150 ms over 200 ms
70-150 ms over 200 ms
75-150 ms over 200 ms
80-150 ms over 200 ms
85-150 ms over 200 ms
FF3-(001-144)#-35#-(1 or 2)#
FF3-(001-144)#-36#-(1-8)#
94
Issue 15
[SLT HOOK FLASH]
[1:SSD-1 2:SSD-2]
[SP. MCO TENANT]
2.x
2.x
3.1