Table of Contents
Advertisement
Panasonic Digital Business System - Programming Manual
April 1997
How To Program
Overview
DBS programming is carried out from an operator telephone (connected to extension port 1) or a
specially enabled display keyset. This manual assumes that programming will be performed from
the operator telephone , extension 200 connected to extension port 1.
After loading the default program, not all system features will be available. Therefore the system
must be programmed to the users requirements.
Any programming changes from initial set must be recorded in the programming table for
maintenance purposes.
Some programming features will require the system to be reset by switching it off and back on.
This will cause the CPU to re-read the system's programmed settings and adjust system operation
accordingly.
Programming method
Loading Default Data
The following procedure loads the default data settings.
1)
Assure the RAM switch on the CPC card is set to the RAMCLR position.
2)
Switch ON the main unit. The LED Data lamp (Red) on the CPC card flickers for
between 10 and 20 seconds then goes out. The default settings are now loaded.
3)
Put the RAM switch to the HOLD side. Default data is protected in memory. Data lamp
flashes continuously.
The system will not function with the RAM switch in the RAMCLR position. Programming changes
are made with RAM switch in the HOLD position.
Initialising The CPC-EX Card
Before programming the CPC-EX card it must be initialised in the same way as previous CPC
cards, plus the system size and number of analogue line cards ( including private circuit cards )
must be set so that the ports are powered up correctly. Use the DASSII steps FF1 6# 1# 1# & FF1
6# 1# 2# to do this.
3
Issue 15
Advertisement
Table of Contents
