Mitsubishi Electric MR-E A Series Instruction Manual page 229

14. SERVO MOTOR
14.6.3 Servo motors with reduction gears
CAUTION
Servo motors are available with reduction gears designed for: general industrial machines and precision
applications.
Servo motors with electromagnetic brakes are also available.
(1) Manufacturing range of servo motor with reduction gear
www.DataSheet4U.com
Servo motors with reduction gears that may be manufactured are indicated by symbols (G1(H), G2) in
the following table. G1 (H) and G2 are symbols appended to the servo motor models.
Reduction Gear Series
Reduction ratio
Servo Motor
HC-KFE13 to 73
HC-SFE52 to 202
Note : Reduction ratios for general industrial machines are nominal values. For actual reduction ratios, refer to (2) and (3) in this section.
(2) HC-KFE series
Reduction Gear Series
Mounting method
Mounting direction
Lubrication
method
Output shaft rotating direction
With electromagnetic brake
Backlash
Permissible load inertia moment
ratio (when converting into the
servo motor shaft)
Permissible speed
(at servo motor shaft)
The actual reduction ratios of the servo motors with reduction gears designed for general industrial
machines are as listed below:
Nominal
Reduction Ratio
1/5
1/12
1/20
The servo motor with reduction gear must be installed in the specified direction.
Otherwise , it can leak oil, leading to a fire or fault.
For the servo motor with reduction gear, transport it in the same status as in the
installation method. Tipping it over can cause oil leakage.
For General Industrial Machines
(Note)
1/6
1/11
1/5
G1
G1 G1
(H) (H)
For General Industrial Machines
Grease lubrication (Already packed)
100W
Packed grease
Mobilplex 46
Mobil Oil
60 minutes or less at reduction gear output shaft
Servo Motor
HC-KFE13(B)G1
9/44
49/576
25/484
(Note) (Note)
1/17 1/29 1/35
1/20
1/12
G1 G1
G1 G1 G1
(H) (H) (H)
HC-KFE G1
Flange mounting
In any directions
200W 400W
750W
1/12 1/20 1/5
New Molynoc
Mobil Grease
No.2 Nisseki
SP Mobil Oil
Mitsubishi
Same as the servo motor output shaft direction.
Available
10 times or less
4500 r/min
HC-KFE23(B)G1
19/96
25/288
253/5000
14 - 22
For Precision Applications
1/43 1/59 1/5 1/9 1/20
G2 G2 G2
G1 G1
G2 G2 G2
(H) (H)
For Precision Applications
HC-KFE G2
Grease lubrication (Already packed)
LDR101BV American Oil Center Research
3 minutes or less at reduction gear output shaft
HC-KFE43(B)G1 HC-KFE73(B)G1
525/6048
625/12544
1/29 1/45
G2
G2 G2
1/5